Lincoln Corsair: Body Closures / Removal and Installation - Power Liftgate Motor

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: LH side shown, RH side similar.

1. On both sides.
   Remove the LH D-pillar trim panel.
   Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
   

1. 
   
   1. Release the clips.
      
   2. Lower the rear headliner.
      

1. Disconnect the electrical connector and detach the retainer.
   

1. Pull out the grommet and route the wiring out of the body.
   

1. NOTICE: Support the liftgate before removing the power liftgate motor. Failure to follow this direction may result in damage to the components.

   Remove the clips and the power liftgate motor.
   

Installation

1. To install, reverse the removal procedure.
   

1. Carry-out the power liftgate initialization.
   Refer to: Power Liftgate Initialization (501-03 Body Closures, General Procedures).