Lincoln Corsair: Steering Wheel and Column Electrical Components / Removal and Installation - Steering Column Control Switch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the retainer and disconnect the steering column control switch electrical connector.
Torque:
27 lb.in (3 Nm)
-
Remove the steering column control switch.
-
Disconnect the electrical connector.
-
Release the locking tab.
-
Remove the steering column control switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component...
Removal
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Overview
The ABS
and stability control systems are comprised of the following
subsystems which assist the driver in maintaining control of the
vehicle:
ABS
EBD
EPB control
ESC
Hill start assist
Hydraulic fade compensation
RSC
Selectable drive modes
Supplemental braking assist
Supports adaptive cruise control
Suppor..
General Specifications
Item
Specification
Normal engine cranking speed (Average)
180-350 RPM
Starting circuit maximum voltage drop (Engine at normal operating temperature) (Average)
1.0 volt
Starter motor maximum load current draw
1200 amps
Starter motor no-load current draw (Average)
50-80 amps
..