Lincoln Corsair: Tire Pressure Monitoring System (TPMS) / General Procedures - Tire Pressure Monitoring System (TPMS) Sensor Activation
Special Tool(s) /
General Equipment
 |
204-D081A
(204-D081)
Tire Pressure Monitor (TPMS) |
Activation
-
NOTE:
The tire pressure sensors will go into a "sleep
mode" when a vehicle is stationary to conserve battery power. The
sensors do not transmit information while in sleep mode. It will be
necessary to wake them up so they will transmit the latest tire pressure
information.
NOTE:
The tire pressure data in the BCM
can be cleared when the module performs a reset. When this occurs the
air pressure DIDs will be reset to the factory default of 1033 kPa
(149.96 psi) and the cluster will display dashes.
Turn the ignition switch to the ON position.
-
Position the special tool against the Left Front (LF) tire sidewall at the tire valve stem.
Use Special Service Tool: 204-D081A
(204-D081)
Tire Pressure Monitor (TPMS).
-
NOTE:
The special tool should provide feedback in the form
of a flashing green light and a beep sound for each successful response
from a tire pressure sensor. This feedback may not always be present,
do not rely on it as a confirmation that the module heard a particular
sensor.
NOTE:
If a sensor does not respond to the special tool
move the vehicle to rotate the wheels at least one-fourth of a turn and
attempt to activate the same sensor again. If the sensor still does not
respond, attempt to activate the same sensor again using the customer
activation tool (if available). If the sensor still fails to train,
attempt to train the sensor with the vehicle doors open.
Press the test button on the special tool to activate the sensor. Activate the sensor at least 2 times.
Use Special Service Tool: 204-D081A
(204-D081)
Tire Pressure Monitor (TPMS).
-
Repeat Steps 2 and 3 for the remaining tires.
-
If the TPMS indicator remains illuminated after adjusting and activating each sensor,
Refer to: Tire Pressure Monitoring System (TPMS) (204-04B Tire Pressure Monitoring System (TPMS), Diagnosis and Testing).
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Special Tool(s) /
General Equipment
204-D081A
(204-D081)
Tire Pressure Monitor (TPMS)
Ford Diagnostic Equipment
Programming
NOTE:
The TPMS can be placed into learn mode using a diagnostic scan tool or manually where a diagnostic scan tool is not available...
Other information:
Special Tool(s) /
General Equipment
Transmission Jack
Wooden Block
Removal
NOTE:
Removal steps in this procedure may contain installation instructions.
Remove the rear halfshafts.
Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation)...
Information On Demand
Note: On Demand information appears on the right-hand side of the
instrument cluster in single gauge view and in the center of the instrument
cluster in dual gauge view when you switch on certain drive modes.
Note: Pure EV information is only available when you switch on the Pure
EV drive mode...