Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Make sure all cylinder head surfaces are clear of
any gasket material, silicone sealant, oil and coolant. The cylinder
head surface must be clean and dry before running a flatness check.
NOTE:
Use a Straightedge that is calibrated by th..
Removal
NOTE:
Removal steps in this procedure may include installation details.
Remove the liftgate mounted rear lamp assemblies.
Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation).
Remove the rear gate trunk module.
Refer to: Rear Gate Trunk Module (RGTM) (501-03 Body Closures, Removal and Installation).
Disconnect th..