Lincoln Corsair: Automatic Transmission - Automatic Transmission – HF45 / Removal - Transmission
NOTE:
The transmission cannot be removed from the vehicle separate
from the engine. Separate the transmission from the engine following the
additional steps in the transmission procedure.
-
Remove the transmission.
Refer to: Transmission (307-01B Automatic Transmission - Automatic Transmission – HF45, Removal and Installation).
Special Tool(s) /
General Equipment
Trolley Jack
Wooden Block
Removal
Drain the Electric Powertrain Cooling System.
Refer to: Cooling System Filling and Bleeding (303-03D Electric
Powertrain Cooling - 2...
Special Tool(s) /
General Equipment
307-163
(T86P-70043-A)
Remover, Stator Case BearingTKIT-1986-LMTKIT-1986-F
307-586Differential bearing cup removerTKIT-2006UF-FLMTKIT-2006UF-ROW
307-741Spring Compressor, F Clutch
307-821Motor Rotor Remover Installer
308-001
(T58L-101-B)
Remover, Pilot Bearing
Hydraulic Press
Puller
Punch
Wooden Block
..
Other information:
Direction Indicators
Push the lever up or down to use
the direction indicators.
Indicating a Lane Change
Tap the lever up or down to make the
direction indicators flash three times to
indicate a lane change.
Welcome Lighting (IF EQUIPPED)
The Lincoln welcome mat projection lights
are on the bottom of the exterior mirror
housings. They project an image onto the
ground a short distance from ..
Activation
Phase 1 - Leak Verification
Run the EVAP Test with the scan tool.
NOTE:
Some small leaks may not be detected using the EVAP Test. If the system
has passed the test but a leak is still suspected, then proceed to
Phase 2.
If the EVAP system failed the EVAP Test, then proceed to Phase 2.
Phase 2 - System Leak Check
Disconnect the fuel va..