Lincoln Corsair: Tire Sealant and Inflator Kit (IF EQUIPPED) / Second Stage: Checking Tire Pressure
WARNING: If the tire does not inflate
to the recommended tire pressure within
15 minutes, stop and call roadside
assistance.
WARNING: The power plug may get
hot after use and should be handled
carefully when unplugging.
Check the air pressure of your tires as
follows:

- Remove the valve cap from the tire valve.
- Firmly screw the air compressor hose
onto the valve stem by turning clockwise.
- Push and turn the dial clockwise to the
air position.
- If required, turn on the compressor and
adjust the tire to the recommended
inflation pressure shown on the tire label
located on the driver's door or door jamb
area. The tire pressure should be
checked with the compressor turned OFF
in order to get an accurate pressure
reading.
- Unplug the hoses, re-install the valve cap
on the tire and return the kit to the
stowage area.
WARNING: Do not stand directly over
the kit while inflating the tire. If you notice
any unusual bulges or deformations in the
tire's sidewall during inflation, stop and call
roadside assistance...
After using the kit to seal your tire, you will
need to replace the sealant canister. Sealant
canisters and spare parts can be obtained
at an authorized Ford dealer...
Other information:
System Operation
Principles of Operation
Power Transfer Unit (PTU) Operation
The PTU has four (4) modes of operation: Connected, Connecting,
Disconnected, and Disconnecting. Each mode is commanded by the AWD
module. The power transfer unit contains a reversible DC
motor and two hall effect position sensors...
Power Steering Fluid Check
Your vehicle is equipped with an electric
power steering (EPS) system. There is no
fluid reservoir to check or fill.
Changing the 12V Battery
WARNING: Batteries normally
produce explosive gases which can cause
personal injury...