Lincoln Corsair: Engine - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Valve Tappets
Removal
-
Remove the camshafts.
Refer to: Camshafts (303-01A Engine - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and Installation).
-
-
If the camshafts and valve tappets are to be reused,
make sure they are assembled in their original positions.
-
Remove the valve tappets.
-
NOTE:
The number on the valve tappets only reflects the
digits that follow the decimal. For example, a tappet with the number
0.650 has the thickness of 3.650 mm.
NOTE:
Install new components as necessary.
Inspect the valve tappets and replace as necessary.
Installation
-
Lubricate the valve tappets with clean engine oil and install the valve tappets.
-
Install the camshafts.
Refer to: Camshafts (303-01A Engine - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and Installation).
-
Road test the vehicle.
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
303-1687Installer, VCT Solenoid Seal
Materials
Name
Specification
Motorcraft® High Performance Engine RTV SiliconeTA-357
WSE-M4G323-A6
Removal
NOTICE:
During engine repair procedures, cleanliness is extremely
important...
Removal
NOTICE:
During engine repair procedures, cleanliness is extremely
important. Any foreign material, including any material created while
cleaning gasket surfaces, that enters the oil passages, coolant passages
or the oil pan can cause engine failure...
Other information:
Special Tool(s) /
General Equipment
303-1252Stretchy Belt Remover/ Installer ToolTKIT-2006UF-FLMTKIT-2006UF-ROW
Knife
Removal
NOTICE:
Under no circumstances should the accessory drive belt,
tensioner or pulleys be lubricated as potential damage to the belt
material and tensioner damping mechanism will occur...
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Check
Start the engine and allow to run for 1 minute. Turn engine off and wait 5 minutes.
With the vehicle in NEUTRAL, position it on a hoist...