Lincoln Corsair: Body Closures / General Procedures - Power Liftgate Initialization
Programming
NOTE:
This procedure clears and then sets new open and close end points in the RGTM memory.
-
Turn the ignition ON.
-
Using a scan tool perform the RGTM self test to complete power liftgate
initialization. From the diagnostic scan tool, enter TOOLBOX > Self
Test > RGTM > Run Selected Procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Inspection
Inspect the body-to-liftgate door dimensions.
Open the liftgate...
Inspection
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH shown, RH similar.
Inspect the body-to-rear door dimensions...
Other information:
Special Tool(s) /
General Equipment
204-161
(T97P-1175-A)
Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2
205-D070
(D93P-1175-B)
Remover, Front Wheel Hub
Tie Rod End Remover
Removal
Remove the wheel and tire...
Auto-Start-Stop Accumulator components
Item
Description
1
Bolts (2 required)
2
Studbolt
3
Auto-Start-Stop accumulator
4
Seal
5
O-ring seal (2 required)
6
Solenoid
7
Transmission case
Mechanical Operation
When
the engine is running, line pressu..