Lincoln Corsair: Engine Cooling - 2.0L EcoBoost (177kW/240PS) – MI4 / Diagnosis and Testing - Cooling Fan Control
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module |
DTC |
Description |
Action |
PCM |
P0480:00 |
Fan 1 Control Circuit: No Sub Type Information |
GO to Pinpoint Test KN |
Global Customer Symptom Code (GCSC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom |
Action |
Start/Run/Move >
Running >
Overheats >
Always |
GO to Pinpoint Test KN |
Start/Run/Move >
Running >
Overheats >
Intermittent |
GO to Pinpoint Test KN |
Pinpoint Tests

PINPOINT TEST KN: VARIABLE SPEED ELECTRIC COOLING FAN MOTOR

 Introduction
Refer to Wiring Diagrams Cell 033 for schematic and connector information.
Normal Operation and Fault Conditions
Refer to the DTC Fault Trigger Conditions.
DTC Fault Trigger Conditions
DTC |
Description |
Fault Trigger Condition |
PCM P0480:00 |
Fan 1 Control Circuit: No Sub Type Information |
Sets if the PCM detects the voltage on the fan control variable (FCV) circuit is not within the expected range.
|
Possible Sources
- Cooling fan circuitry concern
- Cooling fan relay
- Cooling fan clutch solenoid
- Cooling fan module (8B658)
- Cooling fan assembly (8C607)
-
PCM (12A650)
|
System Operation
Engine coolant flows primarily from the engine to the radiator circuit
and back to the coolant pump. Coolant is sent from the coolant pump
through the engine block and cylinder heads...
Special Tool(s)
Coolant/Battery RefractometerROB75240 or equivalent
D-Gas Adapter300-OTC014-R1068 or equivalent
Radiator Tester014-R1072 or equivalent
UView® Combustion Leak TesterUVU560000-R
Diagnostic Trouble Code (DTC) Chart
WARNING:
Before beginning any service procedure in this section,
refer to Safety Warnings ..
Other information:
Removal
Remove the brake disc.
Refer to: Brake Disc (206-04 Rear Disc Brake, Removal and Installation).
Remove the retainer and bolt and position the wheel speed sensor aside.
Remove and discard the wheel bearing and wheel hub bolts.
Remove the wheel bearing and wheel hub.
Installation
..
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Cleaning
Remove the CAC .
Refer to: Charge Air Cooler (CAC) (303-12A Intake Air Distribution and
Filtering - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and
Installation).
NOTE:
Do not use a high-pressure power washer to clean the CAC or damage to the C..