Lincoln Corsair: Automatic Transmission - 8-Speed Automatic Transmission – 8F35/8F40 / Description and Operation - Torque Converter Clutch (TCC)

Lincoln Corsair 2020-2026 Service Manual / Powertrain / Automatic Transmission / Automatic Transmission - 8-Speed Automatic Transmission – 8F35/8F40 / Description and Operation - Torque Converter Clutch (TCC)

TCC Hydraulic Passages

1	Inspect the pump to transmission case hydraulic passages and seals.
2	Inspect the transmission case to main control hydraulic passages.
3	Inspect the main control hydraulic passages.

TCC Hydraulic Circuits

Item	Description
1	Pump output
2	Converter feed
3	TCC
4	Apply
5	Release
6	Cooler
7	Torque converter
8	TCC regulator valve
9	TCC solenoid

Line pressure fills the converter feed circuit with fluid up to 1,130 kPa (160 psi). The converter feed blow off valve prevents excessive pressure from reaching the torque converter. When the TCC solenoid is commanded off, the TCC regulator valve connects the converter feed circuit to the converter release circuit and fluid flows into the torque converter. Fluid exits the torque converter in the converter apply circuit.

Description and Operation - F Clutch

Description and Operation - Main Control Valve Body

Item Description 1 Transmission internal wiring harness frame bolt 2 Transmission internal wiring harness frame 3 Main control-to-transmission case separator plate bolt 4 Main control-to-transmission case separator plate pushpin retainer 5 Main control-to-transmission case separa..

Other information:

Lincoln Corsair 2020-2026 Service Manual: Removal and Installation - Exterior Rear Door Handle Reinforcement

Removal NOTE: LH (left-hand) side shown, RH (right-hand) side similar. Remove the rear door latch. Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). NOTE: This step is only necessary when installing a new component. Release the cable tension by turning the release screw until the handle lever releases from th..

Lincoln Corsair 2020-2026 Service Manual: Removal and Installation - B-Pillar Outer Panel

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spherical Cutter Plasma Cutter Hot Air Gun Air Body Saw 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Seam ..

Autowipers (IF EQUIPPED)

Wet or winter driving conditions with ice, snow or salty road mist can cause inconsistent and unexpected wiping or smearing.

Lincoln Corsair. Autowipers (IF EQUIPPED)

Autowipers On. High sensitivity. Low sensitivity.