Lincoln Corsair: Rear Suspension / Removal and Installation - Wheel Studs
Special Tool(s) /
General Equipment
Removal
-
Remove the wheel bearing and wheel hub.
Refer to: Wheel Bearing and Wheel Hub - AWD (204-02 Rear Suspension, Removal and Installation).
Refer to: Wheel Bearing and Wheel Hub - FWD (204-02 Rear Suspension, Removal and Installation).
-
Press the wheel stud from the wheel bearing and wheel hub flange.
Use the General Equipment: Hydraulic Press
-
Visual check.
Inspect the wheel bearing and wheel hub flange for corrosion or damage. Replace as necessary.
Installation
-
Press the wheel stud into the wheel bearing and wheel hub flange until fully seated.
Use the General Equipment: Hydraulic Press
-
Install the wheel bearing and wheel hub.
Refer to: Wheel Bearing and Wheel Hub - AWD (204-02 Rear Suspension, Removal and Installation).
Refer to: Wheel Bearing and Wheel Hub - FWD (204-02 Rear Suspension, Removal and Installation).
Special Tool(s) /
General Equipment
Vehicle/Axle Stands
Removal
Remove the rear wheel bearing and wheel hub.
Refer to: Wheel Bearing and Wheel Hub - FWD (204-02 Rear Suspension, Removal and Installation)...
Other information:
How Does Adaptive Cruise Control With Stop and Go Work
Adaptive cruise control with stop and go
uses radar and camera sensors to adjust the
speed of your vehicle to maintain a set gap
from the vehicle in front of you in the same
lane while following it to a complete stop.
You can also engage the system to follow a
vehicle in front of you and adjust set speed
while stopped.
What Is Adaptive ..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the retainers and the hood insulation.
Detach the windshield washer hose coupling.
Detach the retainers and position the windshield washer hose from the hood.
On both sides.
Index-mark the hood hinge location ..