Lincoln Corsair: Automatic Transmission - Automatic Transmission – HF45 / Removal and Installation - Damper
Removal
-
Remove the engine.
Refer to: Engine (303-01B Engine - 2.3L EcoBoost (199kW/270PS), Removal).
-
Remove the bolts and the damper.
Installation
-
Install the damper and the bolts.
Torque:
Stage 1:
89 lb.in (10 Nm)
Stage 2:
177 lb.in (20 Nm)
Stage 3:
21 lb.ft (29 Nm)
-
Install the engine.
Refer to: Engine (303-01B Engine - 2.3L EcoBoost (199kW/270PS), Installation).
Configuration
NOTE:
The inverter system controller (ISC) is called the SOBDMC
(secondary on-board diagnostic control module C) in the scan tool.
Using the scan tool, enter the transmission 11-digit
identification and 13-digit strategy recorded from the transmission tag...
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Removal
With the vehicle in NEUTRAL, position it on a hoist...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B1317..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the spare tire cover.
Remove the spare tire.
Remove the spare tire retainer.
Remove the spare tire.
On RH side.
Release the tabs and remov..