Lincoln Corsair: Exterior Trim and Ornamentation / Removal and Installation - Rear Quarter Panel Moulding
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Remove the fasteners and postion the rear splash shield aside.
-
Remove the retainers from rear quarter panel Moulding rear side.
-
Remove the push pins.
-
Remove the retainer clips and moulding.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Diagnostic PID Chart
NOTE:
The inverter system controller (ISC) is called the SOBDMC in the scan tool.
NOTE:
The Diagnostic PID s are located in the inverter system controller.
PID Name
PID Description
Units
GCLTEMP
Generator Coil Temperature
Temperature
MCLTEMP
Motor Coil Temperature
Temperature
..
Special Tool(s) /
General Equipment
204-161
(T97P-1175-A)
Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2
205-D070
(D93P-1175-B)
Remover, Front Wheel Hub
Tie Rod End Remover
Removal
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Remove the retainers and the underbody s..