Lincoln Corsair: Exterior Trim and Ornamentation / Removal and Installation - Rear Door Moulding
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side door shown, RH side door similar.
-
NOTE:
Do not use excessive force when removing retainers, to avoid damage to moulding.
Using a non-marring trim tool, disengage the moulding retainers attaching the moulding to the door.
-
Remove the moulding.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may include installation details.
Remove the liftgate mounted rear lamp assemblies.
Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door...
Other information:
Special Tool(s) /
General Equipment
204-069
(T81P-1104-C)
Remover/Installer, Front Wheel Hub
307-587Differential bearing installer and guideTKIT-2006UF-FLMTKIT-2006UF-ROW
307-791Install, Differential Bearing (AWD)
Hydraulic Press
Puller
DISASSEMBLY
Inspect the differential bearings for damage or excessive wear...
Note: The temporary mobility kit contains
enough sealant compound in the canister
for one tire repair only. See your authorized
Ford dealer for replacement sealant
canisters.
The kit is located under the load floor in the
trunk. The kit consists of an air compressor
to re-inflate the tire and a canister of sealing
compound that will effectively seal most
punctures caused by nails or simila..