Lincoln Corsair: Seatbelt Systems / Removal and Installation - Rear Center Seatbelt Buckle
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the LH rear seat cushion.
Refer to: Rear Seat Cushion Cover (501-10B Rear Seats, Removal and Installation).
-
Disconnect the rear center seatbelt buckle electrical connector.
-
Disconnect the electrical connector.
-
Detach the wiring harness retainer.
-
Remove the LH rear seat recline cover.
-
Remove the retainer.
-
Position the LH rear seat recline cover out and up.
-
Remove the rear center seatbelt buckle.
-
Detach the wiring harness retainer.
-
Remove the bolt.
Torque:
30 lb.ft (40 Nm)
Installation
NOTE:
During installation, make sure the seatbelt webbing is not
twisted and the seatbelts and buckles are accessible to the occupants.
-
To install, reverse the removal procedure.
-
Check the seatbelt system for correct operation.
Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
The cruise controls are on the steering
wheel.
Press the button.
The indicator appears in the information
display. When the system is on, the color of
the indicator changes to indicate the system
status.
Note: Adaptive cruise control must be on
before you can switch lane centering on...
Special Tool(s) /
General Equipment
Interior Trim Remover
Hog Ring Plier
Removal
NOTE:
Driver seat shown, passenger seat similar.
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation)...