Lincoln Corsair: Seatbelt Systems / Removal and Installation - Rear Center Seatbelt Retractor
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the rear seat armrest.
Refer to: Rear Seat Armrest (501-10B Rear Seats, Removal and Installation).
-
Remove the rear head restraint guide sleeves.
Refer to: Rear Head Restraint Guide Sleeve (501-10B Rear Seats, Removal and Installation).
-
Remove the LH rear seat cushion.
Refer to: Rear Seat Cushion Cover (501-10B Rear Seats, Removal and Installation).
-
Remove the rear seat center seatbelt guide bezel.
-
Release the front retainers.
Use the General Equipment: Interior Trim Remover
-
Release the rear retainers.
Use the General Equipment: Interior Trim Remover
-
Route the rear center seatbelt through the seatbelt guide bezel.
-
-
Remove the rear seat outboard child safety seat tether anchor bezel.
-
Unzip the rear seat outboard backrest cover zipper.
-
Position the rear seat backrest cover flap aside.
-
Remove the bolt and position the rear center seatbelt anchor aside.
Torque:
30 lb.ft (40 Nm)
-
Route the rear center seatbelt through the rear seat backrest cover.
-
Remove the rear center seatbelt retractor bolt.
Torque:
30 lb.ft (40 Nm)
-
Position the rear seat backrest cover and foam to access the rear center seatbelt retractor.
-
Remove the rear center seatbelt retractor.
-
Lift the rear center seatbelt retractor up and out.
-
Route the rear center seatbelt through the seatbelt guide.
Installation
NOTE:
During installation, make sure the seatbelt webbing is not
twisted and the seatbelts and buckles are accessible to the occupants.
-
To install, reverse the removal procedure.
-
Check the seatbelt system for correct operation.
Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the LH rear seat cushion.
Refer to: Rear Seat Cushion Cover (501-10B Rear Seats, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the LH rear seat cushion.
Refer to: Rear Seat Cushion Cover (501-10B Rear Seats, Removal and Installation)...
Other information:
NOTE:
AWD suspension shown, FWD similar.
Item
Description
1
Coil spring
2
Stabilizer bar and links
3
Shock absorber
4
Wheel knuckle
5
Wheel bearing and wheel hub assembly
6
Wheel studs
7
Lower arm and bushing assembly
8
Toe link
9
Upper arm
..
Transmission Overview
The Electronically Controlled Continuously Variable Transmission (eCVT) has the following internal components:
Traction Motor
Generator/Starter
High voltage terminals
Pump and filter assembly
Park lock actuator
TFT sensor
Planetary carrier
Differential carrier
High voltage inductor
Transmission fluid auxiliary pump
..