Lincoln Corsair: Handles, Locks, Latches and Entry Systems / Removal and Installation - Liftgate Release Switch
Special Tool(s) /
General Equipment
Removal
-
Remove the liftgate moulding.
Refer to: Liftgate Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
-
Remove the liftgate release switch.
-
Disconnect the liftgate release switch electrical connector.
-
Release the liftgate release switch retaining tabs.
Use the General Equipment: Interior Trim Remover
-
Remove the liftgate release switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear door window regulator and motor...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the rear quarter panel moulding.
Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Fluid Container
Draining
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
NOTE:
Less than half of the fluid may be drained from the
rear electric drive assembly...