Lincoln Corsair: Handles, Locks, Latches and Entry Systems / Removal and Installation - Liftgate Latch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the liftgate latch bolts.
Torque:
177 lb.in (20 Nm)
-
NOTE:
Liftgate shown transparent for clarity.
Remove the liftgate latch.
-
Disconnect the wiring harness electrical connector(s).
-
Remove the liftgate latch.
Installation
-
To install, reverse the removal procedure.
-
If equipped.
Carry out the power liftgate Initialization.
Refer to: Power Liftgate Initialization (501-03 Body Closures, General Procedures).
Removal
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the keyless entry rear antenna...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the liftgate moulding.
Refer to: Liftgate Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation)...
Other information:
Automatic Transmission Fluid Check
The automatic transmission does not have
a transmission fluid dipstick.
The automatic transmission does not
consume fluid. However, the fluid level
should be checked if the transmission is not
working properly, for example if the
transmission slips or shifts slowly or if you
notice some sign of fluid leakage...
WARNING: The system does not
replace the parking brake. When you leave
your vehicle, always apply the parking
brake.
WARNING: You must remain in your
vehicle when the system turns on. At all
times, you are responsible for controlling
your vehicle, supervising the system and
intervening, if required...