Lincoln Corsair: Automatic Transmission - 8-Speed Automatic Transmission – 8F35/8F40 / Removal and Installation - Halfshaft Seal RH - All-Wheel Drive (AWD)
Special Tool(s) /
General Equipment
 |
205-153
(T80T-4000-W)
Handle |
 |
307-758 Installer, Axle Seal -FWD |
 |
307-759 Installer, Axle Seal -AWD |
Puller |
Punch |
Removal
-
Remove the power transfer unit.
-
Using a punch, poke a small hole in the halfshaft seal.
Use the General Equipment: Punch
-
Using a dent puller, remove and discard the halfshaft seal.
Use the General Equipment: Puller
Installation
-
Install a new halfshaft seal on the special tools.
Use Special Service Tool: 205-153
(T80T-4000-W)
Handle.
, 307-759
Installer, Axle Seal -AWD.
-
Using the special tools, install the LH halfshaft seal.
Use Special Service Tool: 205-153
(T80T-4000-W)
Handle.
, 307-758
Installer, Axle Seal -FWD.
-
Install the power transfer unit.
-
Check the transmission fluid level.
Refer to: Transmission Fluid Level Check (307-01A Automatic
Transmission - 8-Speed Automatic Transmission – 8F35/8F40, General
Procedures).
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Flat Headed Screw Driver
Removal
With the vehicle in NEUTRAL, position it on a hoist...
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. SGM
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
APIM
U0293:00
Lost Communication With Hybrid/EV Powertrain Control Module 'A': No Sub Type Information
GO to Pinpo..
Categories

P215/65R15 95H is an example of a tire
size, load index and speed rating. The
definitions of these items are listed
below. (Note that the tire size, load index
and speed rating for your vehicle may
be different from this example.)
P: Indicates a tire, designated by the
Tire and Rim Association, that may be
used for service on cars, sport utility
vehicles, minivans and light trucks. Note:
If your tire size does not begin with a
letter this may mean it is designated by
either the European Tire and Rim
Technical Organization or the Japan Tire
Manufacturing Association.
215: Indicates the nominal width of
the tire in millimeters from sidewall edge
to sidewall edge. In general, the larger
the number, the wider the tire.
65: Indicates the aspect ratio which
gives the tire's ratio of height to width.
R: Indicates a radial type tire.
15: Indicates the wheel or rim
diameter in inches. If you change your
wheel size, you will have to purchase
new tires to match the new wheel
diameter.
95: Indicates the tire's load index. It
is an index that relates to how much
weight a tire can carry. You may find this
information in your owner’s manual. If
not, contact a local tire dealer.
read more