Lincoln Corsair: Electronic Engine Controls - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Engine Oil Pressure (EOP) Sensor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
-
Remove retainers and the underbody shield.
-
Remove the oil pressure sensor.
Torque:
102 lb.in (11.5 Nm)
Installation
-
NOTE:
Do not re-use the EOP sensor if it has been removed. A new sensor must be installed.
To install, reverse the removal procedure.
Materials
Name
Specification
Motorcraft® Orange Concentrated Antifreeze/CoolantVC-3-B
WSS-M97B44-D
Removal
WARNING:
Always allow the engine to cool before opening the cooling
system...
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESA-M1C200-AESE-M1C171-A
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Remove the retainers and the underbody shield...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Pulling downward, remove the cross beam cover.
Refer to: Roof Opening Panel Glass (501-17)
.
Pulling downward, remove the cross beam cover...