Lincoln Corsair: Intake Air Distribution and Filtering - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Air Cleaner
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles. When removing any turbocharger or engine air intake
system component, ensure that no debris enters the system. Failure to
do so may result in damage to the turbocharger.
NOTE:
Removal steps in this procedure may contain installation details.
-
Dislodge and relocate the air cleaner intake pipe.
-
-
Loosen the clamp and position aside the air cleaner outlet pipe.
Torque:
36 lb.in (4.1 Nm)
-
Disconnect the IAT sensor electrical connector.
-
Release the clips and position aside the wiring harness.
-
Detach and remove the air cleaner from the isolators.
-
Clean, inspect and cover all open ports.
Installation
-
Inspect the turbocharger or engine air intake system components and clean, if necessary.
-
To install, reverse the removal procedure.
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Cleaning
Remove the CAC .
Refer to: Charge Air Cooler (CAC) (303-12A Intake Air Distribution and
Filtering - 2...
Special Tool(s) /
General Equipment
Side Cutter Pliers
Hose Clamp Remover/Installer
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESA-M1C200-AESE-M1C171-A
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles...
Other information:
Jacking and Lifting Points
NOTE:
4WD shown, FWD similar.
Only the specified jacking points may be used for jacking and supporting the vehicle.
WARNING:
Before raising the vehicle on a hoist, make sure the hoist
capacity is adequate for the vehicle weight, including any vehicle cargo
or modifications...
Condensation in the Exterior Front Lamps and Rear Lamps
Exterior front lamps and rear lamps have
vents to accommodate normal changes in
air pressure.
Condensation can be a natural by-product
of this design. When moist air enters the
lamp assembly through the vents, there is a
possibility that condensation can occur when
the temperature is cold...