Lincoln Corsair: Front End Body Panels / Removal and Installation - Active Grille Shutter
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the cooling module.
Refer to: Cooling Module (303-03B Engine Cooling - 2.3L EcoBoost (199kW/270PS), Removal and Installation).
Refer to: Cooling Module (303-03A Engine Cooling - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and Installation).
-
If equipped.
Remove the CCM .
Refer to: Cruise Control Module (CCM) (419-03B Cruise Control -
Vehicles With: Adaptive Cruise Control With Lane Centering, Removal and
Installation).
-
-
Remove the upper radiator support insulators.
-
Remove the lower radiator support insulators and seperate the active grille shutter from cooling module.
Installation
-
To install, reverse the removal procedure.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
NOTE:
New exhaust manifold gaskets, studs, nuts and/or
bolts must be installed when an exhaust manifold is serviced...
Special Tool(s) /
General Equipment
204-161
(T97P-1175-A)
Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2
205-D070
(D93P-1175-B)
Remover, Front Wheel Hub
Tie Rod End Remover
Removal
Remove the wheel and tire...