Lincoln Corsair: Front End Body Panels / Removal and Installation - Active Grille Shutter Actuator
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the active grille shutter.
Refer to: Active Grille Shutter (501-02 Front End Body Panels, Removal and Installation).
-
On both sides.
Release the tabs and remove the upper vane bearing.
Install the General Equipment: Flat Headed Screw Driver
-
On both sides.
Remove the vane.
-
-
Disconnect the electrical connector.
-
Release the tab.
-
Remove the active grille shutter actuator.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the cooling module.
Refer to: Cooling Module (303-03B Engine Cooling - 2...
Removal
Remove the windshield wiper pivot arm.
Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal and Installation).
If equipped...
Other information:
Before exporting your vehicle to a foreign
country, contact the appropriate foreign
embassy or consulate. These officials can
inform you of local vehicle registration
regulations and where to find unleaded fuel
or petrol/gas engines or the proper sulfur
fuel for diesel engines...
WARNING: The system may not
detect objects with surfaces that absorb
reflection. Always drive with due care and
attention. Failure to take care may result
in a crash.
WARNING: The system may not
detect small or moving objects, particularly
those close to the ground...