Lincoln Corsair: Engine System - General Information / General Procedures - Piston Selection
Check
NOTE:
Refer to the appropriate Section 303-01 for the specifications.
-
NOTE:
The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
-
Measure the cylinder bore in 2 directions.
-
Select a piston size based on the cylinder bore.
-
NOTE:
For precision fit, new pistons are divided into 3
categories within each size range based on their relative position
within the range. A paint spot or specific size grade on a new piston
indicates the position within the size range.
Choose the piston with the correct paint color or specific size grade.
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...
Adjustment
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...
Other information:
Inspection
Cratering - fatigue failure
Spot glazing - incorrect seating
Scratching - dirty engine oil
Base exposed - poor lubrication
Both edges worn - journal damaged
One edge worn - journal tapered or bearing not seated
..
WARNING: Do not remove or alter
the original equipment floor covering or
insulation between it and the metal floor
of the vehicle. The floor covering and
insulation protect occupants of the vehicle
from the engine and exhaust system heat
and noise. On vehicles with no original
equipment floor covering insulation, do not
carry passengers in a manner that permits
prolonged skin contact with..