Lincoln Corsair: Automatic Transmission - Automatic Transmission – HF45 / Disassembly and Assembly of Subassemblies - Park Lock Actuator
DISASSEMBLY
-
Remove the transmission case cover.
Refer to: Transmission Case Cover (307-01B Automatic Transmission - Automatic Transmission – HF45, Removal and Installation).
-
-
If equipped, cut and discard the tie strap.
-
disconnect the park lock actuator.
-
Remove the park lock actuator bolts.
-
Disconnect and remove the park lock actuator.
ASSEMBLY
-
NOTE:
Make sure park rod is installed in the park rod guide.
Connect and install the park lock actuator.
-
Install the park lock actuator bolts.
Torque:
97 lb.in (11 Nm)
-
-
Connect the park lock actuator.
-
Install a new tie strap.
-
Install the transmission case cover.
Refer to: Transmission Case Cover (307-01B Automatic Transmission - Automatic Transmission – HF45, Removal and Installation).
Special Tool(s) /
General Equipment
204-069
(T81P-1104-C)
Remover/Installer, Front Wheel Hub
307-587Differential bearing installer and guideTKIT-2006UF-FLMTKIT-2006UF-ROW
307-791Install, Differential Bearing (AWD)
Hydraulic Press
Puller
DISASSEMBLY
Inspect the differential bearings for damage or excessive wear...
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
DISASSEMBLY
Remove the bolts and the pump assembly...
Other information:
Electric Power Steering
WARNING: The electric power
steering system has diagnostic checks that
continuously monitor the system. If a fault
is detected, a message displays in the
information display. Stop your vehicle as
soon as it is safe to do so...
Make sure the oil in the crankcase is of the correct
viscosity and at the correct level and that the battery is correctly
charged. Operate the vehicle until the engine is at normal operating
temperature. Turn the ignition switch to the OFF position...