Lincoln Corsair: Engine Ignition - 2.0L EcoBoost (177kW/240PS) – MI4/2.0L EcoBoost (184kW/250PS) – MI4 / Removal and Installation - Spark Plugs

Lincoln Corsair 2020-2026 Service Manual / Powertrain / Engine / Engine Ignition - 2.0L EcoBoost (177kW/240PS) – MI4/2.0L EcoBoost (184kW/250PS) – MI4 / Removal and Installation - Spark Plugs

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the ignition coil-on-plugs.
Refer to: Ignition Coil-On-Plug (303-07A Engine Ignition - 2.0L EcoBoost (177kW/240PS) – MI4/2.0L EcoBoost (184kW/250PS) – MI4, Removal and Installation).

Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.

NOTICE: Do not remove the spark plugs when the engine is hot or cold soaked. Spark plug thread or cylinder head damage can occur. Make sure that the engine is warm (hand touch after cooling down) prior to spark plug removal.

NOTICE: If a spark plug is dropped, internal damage may result and the spark plug must be discarded. The use of a damaged spark plug may cause cylinder misfire resulting in engine damage.
Remove the spark plugs.
Torque: 106 lb.in (12 Nm)

Installation

To install, reverse the removal procedure.

Removal and Installation - Ignition Coil-On-Plug

Removal Remove the Air Cleaner Outlet Pipe. Refer to: Air Cleaner Outlet Pipe (303-12B Intake Air Distribution and Filtering - 2.3L EcoBoost (199kW/270PS), Removal and Installation)...

Engine Emission Control - 2.0L EcoBoost (177kW/240PS) – MI4

Other information:

Lincoln Corsair 2020-2026 Service Manual: General Procedures - Rear Toe Adjustment

Special Tool(s) / General Equipment Wheel Alignment System Adjustment NOTICE: Do not use any tools or equipment to move the wheel and tire assembly or suspension components while checking for relative movement. Suspension damage may occur. The use of tools or equipment will also create relative movement that may not exist when using hand force. Relative movement must be measured..

Lincoln Corsair 2020-2026 Service Manual: Description and Operation - Starting System - Overview

Starting System The starting system controls the cranking of the engine. The PCM energizes the starter relay when it receives inputs from the ignition switch, automatic transmission, and the BCM . When the starter relay is energized, it applies power to the starter motor which cranks the engine. Starting System - with Remote Start If equipped, the remote start system allows the vehic..

Second Stage: Checking Tire Pressure

WARNING: If the tire does not inflate to the recommended tire pressure within 15 minutes, stop and call roadside assistance.

WARNING: The power plug may get hot after use and should be handled carefully when unplugging.

Check the air pressure of your tires as follows:

Lincoln Corsair. Second Stage: Checking Tire Pressure