Lincoln Corsair: Electronic Engine Controls - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Powertrain Control Module (PCM)

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: This step is only necessary when installing a new component.

   Download the module information to the diagnostic tool using the Programmable Modules Installation routine.
   Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).
   Use the General Equipment: Ford Diagnostic Equipment

1. Remove the LH fender splash shield.
   Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
   

1. Remove the retainers and the PCM cover.
   

1. Disconnect the electrical connectors. Remove the retainers and the PCM .
   Torque: 89 lb.in (10 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   Upload the module information from the diagnostic tool using the Programmable Modules Installation routine.
   Refer to: Module Programming (418-01 Module Configuration, General Procedures).
   Use the General Equipment: Ford Diagnostic Equipment

1. NOTE: Key programing is not necessary for this step.

   NOTE: This step is only necessary when installing a new component.

   Carry out the Module Initialization/Parameter Reset procedure. For additional information,
   Refer to: Anti-Theft Key Programming - Scan Tool (419-01B Passive Anti-Theft System (PATS), General Procedures).
   

1. NOTE: This step is only necessary when installing a new component.

   Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.