Lincoln Corsair: Body Closures / Removal and Installation - Liftgate Anti-Pinch Switch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Remove the loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the liftgate anti-pinch switch electrical connector.
-
Gently pull to release the pins and remove the liftgate anti-pinch switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the liftgate.
Remove the high mounted stoplamp...
Removal
NOTE:
LH side shown, RH side similar.
NOTICE:
Support the liftgate before removing the liftgate
strut. Failure to follow this direction may result in damage to the
components...
Other information:
Inspect the camshaft lobes for pitting or damage in the
active area. Minor pitting is acceptable outside the active area. The
active area includes the opening ramp and closing ramp. The opening ramp
is the point where the lifter just begins to lift until the point it
reaches the nose of the lobe...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
SOBDMC
P0711:00
Transmission Fluid Temperature Sensor 'A' Circuit Range/Performance: No Sub Type Information
GO to Pinpo..