Lincoln Corsair: Automatic Transmission - Automatic Transmission – HF45 / Removal and Installation - Halfshaft Seal RH - AWD
Special Tool(s) /
General Equipment
 |
205-153
(T80T-4000-W)
Handle |
 |
307-758 Installer, Axle Seal -FWD |
| Flat Headed Screw Driver |
Removal
-
Remove the RH halfshaft.
Refer to: Front Halfshaft RH - AWD (205-04 Front Drive Halfshafts, Removal and Installation).
-
Remove and discard the RH halfshaft seal.
Use the General Equipment: Flat Headed Screw Driver
Installation
-
Install a new halfshaft seal on the special tools.
Use Special Service Tool: 205-153
(T80T-4000-W)
Handle.
, 307-758
Installer, Axle Seal -FWD.
-
Using the special tools, install the RH halfshaft seal.
Use Special Service Tool: 205-153
(T80T-4000-W)
Handle.
, 307-758
Installer, Axle Seal -FWD.
-
Install the RH halfshaft.
Refer to: Front Halfshaft RH - AWD (205-04 Front Drive Halfshafts, Removal and Installation).
-
Check the transmission fluid level.
Refer to: Transmission Fluid Level Check (307-01B Automatic Transmission - Automatic Transmission – HF45, General Procedures).
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Removal
With the vehicle in NEUTRAL, position it on a hoist...
Removal
To remove the ISC (inverter system controller).
Refer to: Inverter System Controller [SOBDMC] (303-14D Electric Powertrain Control, Removal and Installation)...
Other information:
Overview
The
windshield wiper/washer system is activated by the wiper/washer switch.
The wiper/washer switch is mounted to the right side of the SCCM . The
following functions/ features of the windshield wiper/washer system are:
Mist wipe
Windshield wash (includes front camera wash, if equipped)
Courtesy wipe
Windshield wipers (low/high speed)
Intermittent wipers
..
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
NOTE:
New exhaust manifold gaskets, studs, nuts and/or
bolts must be installed when an exhaust manifold is serviced.
NOTE:
Use a Straightedge that is calibrated by the ..