Lincoln Corsair: Bumpers / Removal and Installation - Front Bumper Cover

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the front wheels and tires.
   Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

1. On both sides.
   Remove the push pins.
   

1. On both sides.
   Release the clips and position front fender moulding aside.
   Use the General Equipment: Interior Trim Remover

1. If equipped.
   Remove the bolts, the screws, the trim pins and the lower reinforcement assembly.
   Torque:
      1.:   18 lb.ft (25 Nm)
      2.:   18 lb.in (2 Nm)

1. Remove the screws.
   Torque: 18 lb.in (2 Nm)

1. Remove the screws.
   Torque: 18 lb.in (2 Nm)

1. On both sides.
   Position the front fender liner aside.
   

1. 
   
   1. Disconnect the front bumper cover harness electrical connectors.
      
   2. Disconnect the front camera harness electrical connector.
      
   3. Disconnect the washer hose and plug the washer hose end.
      

1. On both sides.
   Remove the front bumper cover to fender bracket bolts and release the tabs.
   Torque: 71 lb.in (8 Nm)

1. Remove the push pins and the radiator sight shield.
   

1. Remove the screws.
   Torque: 35 lb.in (4 Nm)

1. With the help of an assistant.
   Release the tabs, the clips and remove the front bumper cover.
   

Installation

1. To install, reverse the removal procedure.
   

1. Vehicles equipped with 360° cameras only.
   Align the 360° cameras.
   Refer to: 360 Degree View Camera Alignment (413-13B Parking Aid - Vehicles With: Parking Aid Camera, General Procedures).
   

1. If replacing the front bumper cover.
   Refer to: Azimuth System Check (413-13C Parking Aid - Vehicles With: Active Park Assist, General Procedures).
   Refer to: Azimuth System Check (413-13A Parking Aid - Vehicles With: Rear Parking Aid, General Procedures).
   Refer to: Elevation System Check (413-13A Parking Aid - Vehicles With: Rear Parking Aid, General Procedures).
   

1. If any sensor fails the check, diagnose the sensor fault.
   Refer to: Parking Aid (413-13C Parking Aid - Vehicles With: Active Park Assist, Diagnosis and Testing).
   Refer to: Parking Aid (413-13A Parking Aid - Vehicles With: Rear Parking Aid, Diagnosis and Testing).