Lincoln Corsair: Engine Cooling - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Block Heater
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Drain the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding
(303-03A Engine Cooling - 2.0L EcoBoost (177kW/240PS) – MI4, General
Procedures).
-
NOTE:
Make sure the block heater wiring is routed and secured away from rotating or hot components.
Disconnect the block heater electrical connector.
-
Remove the block heater.
Torque:
41 lb.ft (55 Nm)
Installation
-
To install, reverse the removal procedure.
-
Fill and bleed the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding
(303-03A Engine Cooling - 2.0L EcoBoost (177kW/240PS) – MI4, General
Procedures).
Special Tool(s) /
General Equipment
ROB75240Coolant/Battery Refractometer (Fahrenheit)
Flushing
WARNING:
Always allow the engine to cool before opening the cooling
system...
Special Tool(s) /
General Equipment
Strap Wrench
Materials
Name
Specification
Motorcraft® Silicone Brake Caliper Grease and Dielectric CompoundXG-3-A
ESA-M1C200-AESE-M1C171-A
Removal
Drain the cooling system...
Other information:
Special Tool(s) /
General Equipment
Door Lift
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH shown, RH similar.
Open the door.
Remove the check arm bolt...
Open the liftgate.
Stop the liftgate movement by pressing
the control button on the liftgate when it
reaches the desired height.Note: Once the liftgate stops moving,
you
can manually move it to the desired height.
Press and hold the control button on the
liftgate until a tone sounds, indicating
programming is complete...