Lincoln Corsair: Instrument Panel and Console / Removal and Installation - Auxiliary Power Point
Special Tool(s) /
General Equipment
.jpg) |
501-194 Remover, Power Point TKIT-2014D-ROW2 TKIT-2014D-FL_ROW |
Removal
-
Open the power point cover.
-
Position the power point extractor so that it engages in the adjacent slots in the power point socket.
Remove Suggested Tool: 501-194
Remover, Power Point.
-
-
Install the receiver cup.
-
Install and tighten the wing nut.
Remove Suggested Tool: 501-194
Remover, Power Point.
-
Tighten the wing nut to pull the power point socket out of the retainer.
Remove Suggested Tool: 501-194
Remover, Power Point.
-
Disconnect the electrical connector.
Installation
-
Connect the electrical connector and push the new power point socket into the retainer.
Special Tool(s) /
General Equipment
Side Cutter Pliers
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Locating the Keyless Entry Keypad
The keypad is near the driver window and
illuminates when you touch it.
Keyless Entry Limitations
Make sure a valid passive key is within one
of the three external detection ranges. These
are approximately 3 ft (1 m) from the front
door handles and the liftgate...
Car Finder
Press the button twice within
three
seconds. A tone sounds and the
direction indicators flash. We
recommend you use this method to locate
your vehicle.
Sounding the Panic Alarm
Press the button to sound the
panic alarm. To turn it off, press
the button again or switch the
ignition on...