Lincoln Corsair: Keyless Entry / Keyless Entry Settings

Switching Keyless Entry On and Off

1. Switch the ignition on using an admin key.
2. Using the information display controls on the steering wheel, select Settings.

   

3. Select Vehicle.
4. Select Locks.
5. Press and hold the OK button until a confirmation message appears in the information display.
6. Switch the ignition off.

Reprogramming the Unlocking Function

You can program the unlocking function so that only the driver door unlocks when you touch the unlock sensor.

Press and hold both the lock and unlock buttons on the remote control for four seconds to disable or enable two-stage unlocking. Disabling two-stage unlocking allows your entire vehicle to unlock with one press of the button.

Intelligent access at the driver door unlocks your entire vehicle when you disable two-stage unlocking.

Enabling two-stage unlocking allows only the driver door to unlock and all of the following become true:

• If you open the driver door first, all other doors remain locked.
• You can unlock all of the other doors from inside your vehicle using the power door lock control on the driver door.
• You can unlock individual doors by pulling the interior door handles on those doors.

Creating Personal Access Codes

To create your own personal access code:

1. Enter the factory-set code.
2. Press 1·2 on the keypad within five seconds.
3. Enter your personal five-digit code.
4. Press 1·2 on the keypad to save personal code one.

The doors lock then unlock to confirm that programming was successful.

To program additional personal access codes, repeat Steps 1-3, then for Step 4:

• Press 3·4 to save personal code two.
• Press 5·6 to save personal code three.
• Press 7·8 to save personal code four.
• Press 9·0 to save personal code five.

Hints:

• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory-set code works even if you have set your own personal code.

Clearing All Personal Access Codes

1. Enter the factory-set five-digit code.
2. Press and release 1·2 on the keypad within five seconds.
3. Press and hold 1·2 for a few seconds. This must be done within five seconds of completing Step 2.

All personal codes erase and only the factory-set five-digit code works.