Lincoln Corsair: Engine System - General Information / General Procedures - Valve Stem Diameter
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
-
Measure the diameter of each intake and exhaust valve
stem at the points shown. Verify the diameter is within specification.
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary...
Valve Train Analysis - Engine Off, Valve Cover Removed
NOTE:
The following component inspections are used to diagnose valve train concerns.
Check for damaged or severely worn parts and correct assembly...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
Upper and lower B-pillar trim panels
Remove the following items:
Remove the front scuff plate trim panel...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The EBB and the ABS module are serviced as an assembly and should not be separated.
NOTE:
The PMI process must begin with the current ABS module installed...