Lincoln Corsair: Engine System - General Information / General Procedures - Piston Inspection
Inspection
-
NOTE:
Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur.
Clean and inspect the (1) ring lands, (2) pin bosses,
(3) skirts and the (4) tops of the pistons. If wear marks, scores or
glazing is found on the piston skirt, check for a bent or twisted
connecting rod.
-
NOTE:
Make sure the oil ring holes are clean.
Using a Piston Ring Groove Scraper, clean the piston ring grooves.
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the piston diameter 90 degrees from the piston
pin and 41 mm (1...
Special Tool(s) /
General Equipment
Dial Indicator
Check
Verify that the cylinder block deck surface and the pistons are clean.
The piston protrusion is measured in-line front and rear avoiding raised or etched marking...
Other information:
Repair
NOTE:
Click here to view a video version of the seat heater mat removal and installation. View
NOTE:
Always install a new heater mat.
NOTE:
During installation, it is allowable to adhere a new heater mat to any adhesive left behind on the foam...
Rear View Camera Guide Lines
Note: Active guide lines and fixed guide lines
are only available when the transmission is
in reverse (R).
Note: The centerline is only available if the
active or fixed guide lines are on.
Active guide lines.
Centerline...