Lincoln Corsair: Liftgate / Setting the Liftgate Opening Height
- Open the liftgate.
- Stop the liftgate movement by pressing
the control button on the liftgate when it
reaches the desired height.
Note: Once the liftgate stops moving,
you
can manually move it to the desired height.
- Press and hold the control button on the
liftgate until a tone sounds, indicating
programming is complete.
Note: You can only use the liftgate control
button to program the height.
Note: You cannot program the height if the
liftgate position is too low.
- The power liftgate now opens at the
programmed height. To change the
programmed height, repeat the steps.
Note: You can fully open the liftgate by
manually pushing it upward to the maximum
open position if it opens in a lower position.
Note: The system recalls the new
programmed height until you reprogram it,
even if you disconnect the battery.
Opening the Liftgate From Inside Your Vehicle
With the transmission in park
(P),
press the button on the instrument
panel.
Note: Be careful when opening or closing
the liftgate in a garage or other enclosed
area to avoid damaging the liftgate...
Closing the Liftgate From Inside Your Vehicle
WARNING: Make sure all persons
are clear of the power liftgate area before
using the power liftgate control...
Other information:
California Civil Code Section 1793.2(d)
requires that, if a manufacturer or its
representative is unable to repair a motor
vehicle to conform to the vehicle’s applicable
express warranty after a reasonable number
of attempts, the manufacturer shall be
required to either replace the vehicle with
one substantially identical or repurchase the vehicle and reimburse the buyer in
an
amount eq..
Special Tool(s) /
General Equipment
303-096
(T74P-6150-A)
Installer, Camshaft Front Oil SealTKIT-2009TC-F
303-1521Alignment Tool, Crankshaft Position SensorTKIT-2010C-FLM
303-1685Alignment Tool, Camshaft
303-1689Holding Tool, Crank Damper
303-409
(T92C-6700-CH)
Remover, Crankshaft SealTKIT-1992-FH/FMH/FLMHTKIT-1993-LMH/MH
303-507Timing Peg, Crankshaft ..