Lincoln Corsair: Seatbelts / Seatbelt Height Adjustment. Seatbelt Warning Lamp and Indicator Chime
Seatbelt Height Adjustment
WARNING: Position the seatbelt
height adjuster so that the belt rests across
the middle of your shoulder. Failure to
adjust the seatbelt properly could reduce
the effectiveness of the seatbelt and
increase the risk of injury in a crash.

To adjust the shoulder belt height, squeeze
the button and slide the height adjuster up
or down. Release the button and pull down
on the height adjuster to make sure it is
locked in place.
Seatbelt Warning Lamp and Indicator Chime
This lamp illuminates and an
indicator chime will sound if the
driver seatbelt has not been
fastened when the vehicle's ignition is turned
on.
Conditions of operation

The front outboard and rear safety restraints
in the vehicle are combination lap and
shoulder belts.
Insert the belt tongue into the proper
buckle (the buckle closest to the direction
the tongue is coming from) until you hear
a snap and feel it latch...
WARNING: The system will only
provide protection when you use the
seatbelt correctly.
This system monitors all seating positions
and provides audio and graphic feedback...
Other information:
Leak Check Test
With the vehicle in NEUTRAL, position it on a hoist.REFER to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Inspect the gasket and sealing areas for evidence of leakage.
Trace the transmission fluid leak to the highest point...
Repair
NOTE:
Mouldings located on the front and rear window frames may
experience minor scratches from vehicle shipment or car wash racks. The
imperfections may be repaired instead of replacing components by
following the steps below.
NOTE:
Scratches deep enough to cause a thumb nail to catch cannot be repaired and the component must be replaced...