Lincoln Corsair: Roof Opening Panel / Removal and Installation - Roof Opening Panel Glass
Removal
NOTE:
This procedure is for the roof opening panel sliding glass only.
-
Open the roof opening panel glass slightly to gain access to the roof opening panel glass screws.
-
If closed, open the roof opening panel shield.
-
Remove the RH roof opening panel glass screws.
-
Remove the LH roof opening panel glass screws.
-
With the help of an assistant, remove the roof opening panel glass.
Installation
-
With the help of an assistant, install the roof opening panel glass.
-
Install the LH roof opening panel glass screws finger tight.
Torque:
53 lb.in (6 Nm)
-
Install the RH roof opening panel glass screws finger tight.
Torque:
53 lb.in (6 Nm)
-
Close the roof opening panel glass.
-
Align the roof opening panel glass.
Refer to: Roof Opening Panel Alignment (501-17 Roof Opening Panel, General Procedures).
-
Carry out the power roof opening panel initialization.
Refer to: Power Roof Opening Panel Initialization (501-17)
.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Roof opening panel glass or shield motor
Remove the headliner...
Other information:
WARNING:
Before working on or disconnecting any of the fuel tubes or fuel
system components, relieve the fuel system pressure to prevent
accidental spraying of fuel. Fuel in the fuel system remains under high
pressure, even when the engine is not running...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door window control switch bezel assembly.
Release the locking tabs from the rear door window control switch bezel assembly...