Lincoln Corsair: Handles, Locks, Latches and Entry Systems / Removal and Installation - Hood Latch
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the air cleaner inlet pipe.
Refer to: Air Cleaner Intake Pipe (303-12B Intake Air Distribution and
Filtering - 2.3L EcoBoost (199kW/270PS), Removal and Installation).
Refer to: Air Cleaner Intake Pipe (303-12A Intake Air Distribution and
Filtering - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and
Installation).
-
Remove the hood latch.
-
If equipped.
Disconnect the hood ajar switch.
-
Remove the bolts from the hood latch.
Torque:
93 lb.in (10.5 Nm)
-
Detach the hood release cable from the mounting bracket.
-
Disconnect the hood latch release cable end and remove the hood latch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The fuel filler door latch is serviced with the fuel filler door assembly.
Remove the fuel filler door assembly.
Refer to: Fuel Filler Door Assembly (501-03 Body Closures, Removal and Installation)...
Removal
Front Cable
Remove the hood latch.
Refer to: Hood Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation)...
Other information:
Keyless Warning Alert
The horn will sound twice when you exit your
vehicle with the intelligent access key and
your vehicle is in RUN, indicating your vehicle
is still on.
Headlamps On Warning Chime
Sounds when you have left the headlamps
or parking lamps on and open the driver door
with the vehicle off...
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.
If an obvious cause for an observed or reported concern is
found, correct the cause (if possible) before proceeding to the next
step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...