Lincoln Corsair: Handles, Locks, Latches and Entry Systems / Removal and Installation - Fuel Filler Door Latch
Removal
NOTE:
The fuel filler door latch is serviced with the fuel filler door assembly.
-
Remove the fuel filler door assembly.
Refer to: Fuel Filler Door Assembly (501-03 Body Closures, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the driver door window control switch and bezel as an assembly...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the air cleaner inlet pipe.
Refer to: Air Cleaner Intake Pipe (303-12B Intake Air Distribution and
Filtering - 2...
Other information:
NOTE:
This step is only necessary when installing a new PTU or replacing a PTU seal.
Install the PTU heat shield.
Torque:
89 lb.in (10 Nm)
NOTE:
This step is only necessary when installing a new PTU or replacing a PTU seal...
Removal
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the keyless entry rear antenna.
Disconnect the keyless entry rear antenna electrical connector...