Lincoln Corsair: Front Seats / Removal and Installation - Driver Multi-Contour Seat Module [SCMG] - Vehicles With: Multi-Contour Seats

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: Drivers seat SCMG (driver multi-contour seat module) shown, passenger seat SCMH (passenger multi-contour seat module) similar.

1. NOTE: This step is only necessary when installing a new component.

   NOTE: The PMI (programmable module installation) process must begin with the current SCMG (driver multi-contour seat module) or SCMH (passenger multi-contour seat module) installed. If the current SCMG (driver multi-contour seat module) or SCMH (passenger multi-contour seat module) does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

   Using a diagnostic scan tool, begin the PMI process for the SCMG or SCMH following the on-screen instructions.
   

1. Remove the front seat.
   Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
   

1. Remove the front seat backrest panel.
   Refer to: Front Seat Backrest Panel (501-10A Front Seats, Removal and Installation).
   

1. NOTE: After disconnecting the hose and lock assemblies, verify the black O-ring and white spacer remains with each hose.

   NOTE: When connecting the hose and lock assemblies, an audible click must be heard for correct installation.

   Release the locking tabs and disconnect the hose and lock assemblies from the SCMG and position aside.
   

1. 
   Remove the SCMG .
   
   1. Disconnect the electrical connector.
      
   2. Lift upwards on the SCMG to release the rear locking clip.
      
   3. Rotate the SCMG to release the side locking clips.
      

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   Using a diagnostic scan tool, complete the PMI process for the SCMG or SCMH following the on-screen instructions.