Lincoln Corsair: Rear Drive Axle/Differential / Removal and Installation - Drive Pinion Seal

Lincoln Corsair 2020-2025 Service Manual / Chassis / Driveline / Rear Drive Axle/Differential / Removal and Installation - Drive Pinion Seal

Special Tool(s) / General Equipment

	205-208 (T83T-4676-A) Installer, Drive Pinion Oil Seal TKIT-1983-F TKIT-1983-FLM TKIT-1983-FX
Flat Headed Screw Driver

Materials

Name	Specification
Motorcraft® Premium Long-Life Grease XG-1-E1	ESA-M1C75-B

Removal

Remove the drive pinion flange.
Refer to: Drive Pinion Flange (205-02 Rear Drive Axle/Differential, Removal and Installation).

Using a general equipment, remove and replace the drive pinion seal.
Use the General Equipment: Flat Headed Screw Driver

Clean and inspect the drive pinion and pinion seal mating surface.

Installation

Lubricate the new drive pinion seal lip with grease.
Material: Motorcraft® Premium Long-Life Grease / XG-1-E1 (ESA-M1C75-B)

Using the special tool, install the new drive pinion seal.
Use Special Service Tool: 205-208 (T83T-4676-A) Installer, Drive Pinion Oil Seal.

Install the drive pinion flange.
Refer to: Drive Pinion Flange (205-02 Rear Drive Axle/Differential, Removal and Installation).

Removal and Installation - Drive Pinion Flange

S..

Removal and Installation - Rear Drive Unit (RDU) Actuator Motor

Removal Remove the rear axle assembly. Refer to: Axle Assembly (205-02A) . NOTICE: The RDU contains axle fluid. To prevent spillage, do not tilt the RDU during actuator motor removal or installation...

Other information:

Lincoln Corsair 2020-2025 Service Manual: Removal and Installation - A-Pillar Outer Panel Section and Reinforcement

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spherical Cutter Hot Air Gun 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Flexible Foam Repair3M™ 08463, LORD Fuso..

Lincoln Corsair 2020-2025 Service Manual: Removal and Installation - Rear Door Check Arm

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH shown, RH similar. Open the door. Remove the check arm bolt. Torque: 18 lb.ft (25 Nm) Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). ..

Creating a Vehicle Wi-Fi Hotspot

You can create a Wi-Fi hotspot in your vehicle and allow devices to connect to it for access to the Internet.

Lincoln Corsair. Creating a Vehicle Wi-Fi Hotspot Select the settings option on the feature bar.

Press Lincoln Connect. Press Vehicle Hotspot.