Lincoln Corsair: Automatic Transmission External Controls - 8-Speed Automatic Transmission – 8F35/8F40 / General Procedures - Transmission Park by Wire Manual Release
Activation
-
NOTE:
If the vehicle battery is dead or there is no electrical power available, connect an external power source.
Apply the parking brake.
-
Remove the manual park release cable access cover
-
NOTE:
The brakes must be applied from the driver's seat while releasing the vehicle from park.
While applying the brakes, pull the transmission park manual release cable out until it locks..
-
NOTE:
The brakes must be applied from the driver's seat while releasing the parking brake.
While applying the brakes, release the parking brake.
-
Disconnect the battery. The vehicle will remain in neutral for emergency towing purposes.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
-
When the repair is complete, connect the battery.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
-
NOTE:
The brakes must be applied from the driver's seat
while disengaging the transmission park manual release cable.
While applying the brakes, disengage the transmission park manual release cable.
-
Pull the transmission park manual release cable out until it unlocks.
-
Allow the transmission park manual release cable to retract. Stow the cable strap.
-
Install the manual park release cable access cover.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the driver airbag.
Refer to: Driver Airbag (501-20B Supplemental Restraint System, Removal and Installation)...
Other information:
General Equipment
Dial indicator
Dial indicator fixture
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Position the crankshaft to the rear of the cylinder block.
Zero the Dial Indicator Gauge with Holding Fixture...
C Clutch Exploded View
Item
Description
1
C (3, 7) clutch pressure plate
2
Sunshell
3
C (3, 7) clutch friction plates
4
C (3, 7) clutch steel plates
5
Wave spring
6
C (3, 7) clutch piston apply ring
7
Snap ring
8
C (3, 7) clutch piston return s..