Lincoln Corsair: Wipers and Washers / Description and Operation - Wipers and Washers - Overview
Overview
The
windshield wiper/washer system is activated by the wiper/washer switch.
The wiper/washer switch is mounted to the right side of the SCCM . The
following functions/ features of the windshield wiper/washer system are:
-
Mist wipe
-
Windshield wash (includes front camera wash, if equipped)
-
Courtesy wipe
-
Windshield wipers (low/high speed)
-
Intermittent wipers
-
Speed dependent wipers
-
Wiper activated exterior lamps
-
Rain sensitive wipers (if equipped)
-
Rear window wipe/wash
-
Heated wiper park (if equipped)
The intermittent/rain sensitive wipers have 6 intermittent /sensitivity settings.
System Operation
System Diagram
Item
Description
1
Rain Sensor
2
SCCM
3
GWM
4
BCM
5
IPC
6
PCM
7
BCMC
8
Wiper Relay
9
BCMC
10
Rear Washer Relay
11
Rear Wiper Motor
12
Washer Motor
13
Windshield Wiper Motor
14
HS-CAN3
15
LIN LIN
16
HS-CA..
Other information:
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Flat Headed Screw Driver
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Remove the front RH halfshaft.
Refer to: Front Halfshaft RH..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the retainers and the hood insulation.
Detach the windshield washer hose coupling.
Detach the retainers and position the windshield washer hose from the hood.
On both sides.
Index-mark the hood hinge location ..