Lincoln Corsair Manuals

Lincoln Corsair: Roof Opening Panel / Description and Operation - Roof Opening Panel - Overview

Lincoln Corsair 2020-2023 Service Manual / Body and Paint / Body and Paint / Roof Opening Panel / Description and Operation - Roof Opening Panel - Overview

Panoramic Roof Opening Panel

The roof opening panel consists of the following:

  • Air deflector
  • Front sliding glass panel (sunroof)
  • Front sliding glass panel motor (sunroof motor)
  • Shield (sunshade) assembly
  • Shield (sunshade) motor
  • Blinds (concertina blinds)
  • Roof panel fixed glass (panoramic)
  • Roof opening panel frame assembly
  • Roof opening panel control switch

The roof opening panel is an electronically operated glass panel that can be opened, closed or tilted (vent position) by the roof opening panel control switch and the vent switch. Actuating the switches supplies a signal to the roof opening panel motor/module. The front sliding glass panel and the shield (sunshade) use two integrated motors/modules that are serviced together as assemblies. The roof opening panel has one-touch open and one-touch close features that are activated when the switch is pressed to the second detent on the glass open or close side of the switch (the sliding glass panel close switch acts as a vent switch when the glass is in the closed position). Additionally the shield (sunshade) switch has one-touch open feature that is activated when the switch is pressed to the second detent on the shield open side of the switch.

The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (front sliding or fixed glass) has been removed or adjusted, or if the roof opening panel frame has been removed. For additional information, refer to:For additional information, refer to:
Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).

Additionally there is a roof opening panel fixed glass (panoramic). The roof opening panel fixed glass is attached with 6 screws and can be aligned.

    Specifications

      Specifications Item Specification Front sliding glass panel to front trim panel flushness 0.066 ± 0...

    Description and Operation - Roof Opening Panel - System Operation and Component Description

    System Operation Item Description 1 BCM 2 Roof Opening Panel Control Switch 3 Sliding Glass Motor / Module 4 Shade Motor Roof Opening Panel Operating System The accessory delay relay in the BCM supplies voltage through fuse F6 (10A) to the sliding glass motor / module allowing the motors to respond to roof opening panel control sw..

    Other information:

    Lincoln Corsair 2020-2023 Service Manual: General Procedures - Wheel to Hub Runout Minimization


    Check NOTE: Wheel-to-hub optimization is important. Clearance between the wheel and hub can be used to offset or neutralize the Road Force® or run-out of the wheel and tire assembly. For every 0.001 inch of wheel-to-hub clearance, the Road Force® can be affected between 1 and 3 pounds depending on the tire stiffness. NOTE: The example below illustrates how the clearance betw..

    Lincoln Corsair 2020-2023 Service Manual: Description and Operation - Rear Suspension - Overview


    Overview The rear suspension consists of the following components: Coil springs Lower arm and bushing assemblies Stabilizer bar and links Shock absorbers Toe links Upper arms Wheel bearing and wheel hub assemblies Wheel knuckles Wheel studs Suspension height sensor The rear suspension uses 2 parallel arms (1 upper and 1 lower). Each arm has..

    Categories

    Creating a Vehicle Wi-Fi Hotspot

    You can create a Wi-Fi hotspot in your vehicle and allow devices to connect to it for access to the Internet.

    Lincoln Corsair. Creating a Vehicle Wi-Fi Hotspot Select the settings option on the feature bar.

    Press Lincoln Connect. Press Vehicle Hotspot.

    read more

    Copyright © 2023 www.licorsair.com