Other information:
Configuration
NOTE:
The inverter system controller (ISC) is called the SOBDMC
(secondary on-board diagnostic control module C) in the scan tool.
Using the scan tool, enter the transmission 11-digit
identification and 13-digit strategy recorded from the transmission tag...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the rear quarter panel moulding.
Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation)...