Lincoln Corsair: Instrument Panel and Console / Removal and Installation - Glove Compartment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
-
Open the glove compartment.
-
Depress the stop tabs and lower the glove comaprtment.
-
Remove the dampener strap.
-
Fully lower the glove compartment, and the glove compartment off the hinges.
-
Release the clips and remove the RH instrument panel end cap.
-
Release the clips and remove the glove compartment trim panel.
-
Remove the bolts and the glove compartment close out.
-
Disconnect the electrical connector.
Torque:
22 lb.in (2.5 Nm)
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Side Cutter Pliers
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
WARNING:
Service of the high voltage system on this vehicle is
restricted to qualified personnel. The required qualifications vary by
region. Always observe local laws and legislative directives regarding
electric vehicle service. Failure to follow this instruction may result
in serious personal injury or death...
The body consists of the following:
Front bumper constructed of high-strength aluminum
Rear bumper constructed of Boron ultra high-strength steel
Front frame rails constructed of Dual Phase (DP) 600 high-strength steel
Rear frame rails constructed of Boron ultra high-strength steel
Fender reinforcement tube constructed of Dual Phase (DP) 800 high-strength steel
..