Lincoln Corsair: Seatbelt Systems / Removal and Installation - Front Seatbelt Buckle
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
-
Remove the front seatbelt buckle.
-
Detach the wiring harness retainers.
-
Disconnect the electrical connector.
-
Remove the bolt.
Torque:
26 lb.ft (35 Nm)
Installation
NOTE:
During installation, make sure the seatbelt webbing is not
twisted and the seatbelts and buckles are accessible to the occupants.
-
To install, reverse the removal procedure.
-
Check the seatbelt system for correct operation.
Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).
Adjustment
NOTE:
Typical D-ring shown, others similar.
If required, remove the necessary trim panel(s).
Fold the seatbelt as indicated...
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
PCM
P0068:00
MAP / MAF - Throttle Position Correlation: No Sub Type Information
GO to Pinpoint Test DV
PCM
P0120:00..
Driver and Passenger Knee Airbags
Driver and passenger knee airbags are
located under or within the instrument panel.
During a crash, the restraints control module
may activate the driver and passenger knee
airbags (individually or both) based on crash
severity and respective occupant conditions.
Under certain crash and occupant conditions, the driver and passenger knee
airbags may
deploy ..