Lincoln Corsair: Supplemental Restraint System / Removal and Installation - C-Pillar Side Impact Sensor

Removal

  WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash.

NOTE: LH (left-hand) shown, RH (right-hand) similar.

NOTE: Removal steps in this procedure may contain installation details.

1.   WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.

   Refer to: Pyrotechnic Device Health and Safety Precautions (100-00 General Information, Description and Operation).
   

1. Depower the SRS .
   Refer to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures).
   

1. Remove the rear scuff plate trim panel.
   Refer to: Rear Scuff Plate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
   

1. NOTE: Second row seat removed for clarity.

   NOTE: Follow the unique instructions or graphic for this step in the installation.

   Release the clips and position the loadspace trim panel away enough to access the C-pillar side impact sensor.
   

1. 
   Remove the C-pillar side impact sensor.
   
   1. Disconnect the electrical connector.
      
   2. Remove the bolt.
      Torque: 106 lb.in (12 Nm)
   3. Remove the C-pillar side impact sensor.
      

Installation

1. NOTE: The C-pillar side impact sensor mating surfaces must be smooth and allow for a flush attachment to each other.

   To install, reverse the removal procedure.
   

1. Position the rear door weatherstrip so that it overlaps the load space trim panel.
   

1. Repower the SRS .
   Refer to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures).