Lincoln Corsair: Security / Anti-Theft Alarm System Settings
What are the Alarm Security Levels
You can select two levels of alarm security,
all sensors and perimeter sensing.
All Sensors
All sensors is the standard setting.
In all sensors, all equipped sensors are on
when you arm the alarm.
Note: Do not arm the alarm with all sensors
if passengers, animals or other moving
objects are inside your vehicle.
Perimeter Sensing
In perimeter sensing, the interior sensors are
off when you arm the alarm.
All the other equipped sensors activate when
you arm the alarm in this mode.
Setting the Alarm Security Level
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press Alarm System.
- Press Sensor Set.
- Press a setting.
What Is Ask on Exit
You can choose which level of security you
require after you switch the ignition off.
Note: If you do not choose a setting, the
system defaults to all sensors.
Switching Ask on Exit On and Off
- Press Settings on the touchscreen.
- Press Vehicle Settings.
- Press Alarm System.
- Switch Ask on Exit on or off.
Passive Anti-Theft System
What Is the Passive Anti-Theft System
The passive anti-theft system prevents
someone from starting the vehicle with an
incorrectly coded key...
Security – Information Messages
Security – Frequently Asked Questions
What should I do if there is any potential alarm problem with my
vehicle?
Take all remote controls to an
authorized dealer if there is any
potential alarm problem with your
vehicle...
Other information:
Tips for Use of the Kit
To ensure safe operation of the kit:
Read all instructions and cautions fully.
Before operating the kit, make sure your
vehicle is safely off the road and away
from moving traffic. Turn on the hazard
lights.
Always set the parking brake to ensure
the vehicle doesn't move unexpectedly...
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door latch.
Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
NOTE:
This step is only necessary when installing a new component...